I'm not by far at the level you gurus are, but here are a couple of my scans
I've used Kinect V2 and RealSense R200 for the meshing, re-did the topologies and cleaned them up a bit in ZBrush with a touch of Max, and reimported into Agisoft Photoscan for the texturing. The small sculpture is the only remaining Brancusi work of art in Romania, and the Government contracted us for doing the 3D scan.https://sketchfab.com/attreyu/models
On a tangent, not so much scanning, but a lot of CAD work (very basic photogrammetry with my Inspire 1 - Photoscan - Max - Inventor for the STEP/IGES conversion) and then some CAM (milling on my Stepcraft, imported from Inventor and milled using Aspire) went into the creation of a 3D model of Bucharest, Romania's urban area and then the fabrication of a 3 x 3 meter mock-up in polystirene - split over 36 smaller tiles. The customer was the Italian Ambassy.
You do not have the required permissions to view the files attached to this post.