Hello Everyone,
I have been using Leica cyclone from last 4 years, and couple of days ago I upgrade to 9.1.5 version. I saw Fly mode in toolbar I was very excited to use this command, actually, I needed this fly command in Leica Cyclone for QC and some other process, finally it has updated. When I use the fly command in a cyclone with point cloud and model it’s not going smoothly. When I use a fly command with the only model it’s going smoothly. Anyone having the same problem or it’s happening for me only. Is there any solution?
Thanks and regards
Shiva
Specialist-Laser scanning 3D Modeling
"Fly Mode" command in Leica Cyclone
-
- I have made <0 posts
- Posts: 3
- Joined: Sat Dec 13, 2014 7:03 am
- 9
- Full Name: SJewoor
- Company Details: Plant Engineering and Geomatic Service
- Company Position Title: Application Engineer-3D Modeler
- Country: India
- Linkedin Profile: Yes
-
- I have made 10-20 posts
- Posts: 15
- Joined: Wed May 06, 2015 12:18 am
- 8
- Full Name: Sam
- Company Details: ---
- Company Position Title: ---
- Country: USA
- Linkedin Profile: No
Re: "Fly Mode" command in Leica Cyclone
I haven't had an opportunity to learn the fly mode yet, but I am curious of your initial thoughts. Does it look nice when it's running smoothly, and can you save the fly through to a video that can be played at a later time?
-
- I have made 90-100 posts
- Posts: 99
- Joined: Sat Mar 19, 2011 5:16 am
- 13
- Full Name: Yuelin
- Company Details: Leica Geosystems
- Company Position Title: Lead software engineer
- Country: USA
- Linkedin Profile: No
- Has thanked: 1 time
- Been thanked: 11 times
Re: "Fly Mode" command in Leica Cyclone
You can try to increase the preference "max load points" to 50 or 100 million points if your computer has larger memory.