I have been having an issue when importing Pxx scan data. On approximately 10 percent of the scans that I import there is missing data. Usually all of the data imports when I re-import the data. I have tried using import project and import partial project with the same results. If I import the same data two different times the issue is not with the same scans, so there is not an issue with the raw scan files. I have tried importing on another machine and did have the same issue.
Has anyone seen this issue? I have attached a screenshot showing the issue.
Cyclone Import Issue
-
- V.I.P Member
- Posts: 330
- Joined: Tue Nov 20, 2007 3:51 am
- 16
- Full Name: Chris Widmer
- Company Details: KCI
- Company Position Title: 3D Scanning Manager
- Country: USA
- Linkedin Profile: Yes
- Location: Atlanta, Georgia
- Has thanked: 3 times
- Been thanked: 8 times
Cyclone Import Issue
You do not have the required permissions to view the files attached to this post.
- Phil Marsh
- Administrator
- Posts: 2490
- Joined: Sun Aug 12, 2007 2:28 pm
- 16
- Full Name: Phil Marsh
- Company Details: Laser Scanning Forum Ltd
- Company Position Title: Director
- Country: UK
- Skype Name: phil.h.marsh
- Linkedin Profile: Yes
- Location: Barnsley, UK
- Has thanked: 119 times
- Been thanked: 36 times
- Contact:
-
- V.I.P Member
- Posts: 330
- Joined: Tue Nov 20, 2007 3:51 am
- 16
- Full Name: Chris Widmer
- Company Details: KCI
- Company Position Title: 3D Scanning Manager
- Country: USA
- Linkedin Profile: Yes
- Location: Atlanta, Georgia
- Has thanked: 3 times
- Been thanked: 8 times
Re: Cyclone Import Issue
Around 12 million data points per setup. Probably something in the range of 0.1'x0.1' at 100'Phil Marsh wrote:What resolution are these scanned on?