Hello everyone,
I have a problem with processing data in HUB v 5.3.1. I have a few datasets and if I want to process it, I have to try to click on PROCESS button a many times when it starts, it writes to me that "processing failed". If it´s start, after approx 4 hours, it has stopped, it marks as "green ok" but in the processing folder, there are no results, no trajref points txt and other results. Please, can you tell me about this problem or do you have any solutions? I have in this time 8 loops, and processed I have only 2 loops, I don´t know where is problem :-/
Thank you very much for any answer.
Libor
Processing in HUB
- lipo80
- I have made <0 posts
- Posts: 4
- Joined: Wed May 22, 2019 1:18 pm
- 4
- Full Name: Libor Polak
- Company Details: TOPGIS Brno
- Company Position Title: laserscanning specialist
- Country: Czech
- Linkedin Profile: Yes
- Location: Czech Republic
-
- I have made 10-20 posts
- Posts: 15
- Joined: Mon Nov 02, 2020 10:49 am
- 3
- Full Name: Ektoras Avgitidis
- Company Details: Terrestrial Laser Scanners
- Company Position Title: Technical Support Engineer
- Country: United Kingdom
- Linkedin Profile: Yes
- Has thanked: 1 time
- Been thanked: 1 time
Re: Processing in HUB
Hello Libor,
This usually happens when you drag and drop many data-sets and HUB has too much cached data to process. Kindly, close and open HUB again, and then try to reprocess the data.
Let me know if you still face any issues or if you need any further assistance.
- Ektor
This usually happens when you drag and drop many data-sets and HUB has too much cached data to process. Kindly, close and open HUB again, and then try to reprocess the data.
Let me know if you still face any issues or if you need any further assistance.
- Ektor